美国网件(NETGEAR) - 技术支持

FVS318G Version 4.3.3-6

发布日期：2015年10月29日

修复问题

Routers that have FAILED their PCI Compliance SCANS.
Device sometimes hang issue.

待修复问题

[CLI]Device is accepting start IP address is larger than end IP address in IPv6 Address pool table.
Device is not accepting mode config pool IPs for a specific range of addresses through CLI.
Not able to change to IPv4/IPv6 dual mode through CLI.
Unable to login to the device GUI after configuring custom portal as default.
Device is not showing prefix length for IPv6 WAN address in router status and WAN setup page.
Sometimes TELNET session to the device is not accessible.
List of services of server group are not displaying in CLI show command.
Device is not showing proper error message while performing ping and trace route when the selected local gateway WAN is down.
Device is showing error "IP subnet conflicting with WAN1" while adding multihoming IP address when WAN ISP type is PPPoE/PPTP.
Opened ports are getting closed when we make changes to other rules in Port Triggering page.
Device WAN not able to connect with the Windows PPTP server.
Not able to establish IPv6 SSL-VPN tunnel from java based browsers with java 8 update 20 version.
Unable to run the FTP traffic from Filezilla client over SSL Port forwarding tunnel in the Windows7 64 bit host.
Unable to establish Port forwarding tunnel from Windows7 64 bit IE9 browser.
[SSL VPN] tunnels establishment failed for Windows 8.1 64 bit IE11 browser.
Link detection processes are seen for WAN3 and WAN4 also but device is having only WAN1 and WAN2.
Observed critical error when we click on trace route option, if ping though VPN tunnel is selected.
Note: Support 25 VoIP phone calls. Next release we will support 50 VoIP phone calls.

升级办法：

在升级之前，请把设备的配置信息都记录好，你可能在升级之后需要使用到这些信息。这些重要的信息包括登陆密码，安全设定，VPN 策略及 ISP 的配置信息等等。
首先从官方网站下载升级文件，一切准备就绪就可以开始升级。

下载 Firmware到本地计算机，下载的Firmware需放到英文目录下，如d:/FVS318Gv2，不要放在桌面或中文目录下。
通过浏览器登陆到管理页面。
在Administration > Settings Backup & Upgrade > Router Upgrade菜单中点击“浏览”按钮，选中下载的Fimware文件，并点击upload。在弹出的页面中点击“确定”FVS318Gv2开始升级。
升级完成后，FVS318Gv2将显示系统已成功升级，并自动重新启动
恢复出厂设置值，即在通电的情况下按着复位键约15秒即可。