|
发布日期：2010年8月3日
注意：FVS336G 升级到 Version 2.X 后需重新恢复出厂设置值，Version1.X 和 2.X 的配置文件不能兼容，因此不要把 Version1.X 配置文档用到 Version 2.X 的软件版本上。
修正的问题：
- WAN2 PPPOE is reconnecting when WAN is configured in Load balancing mode with DNS certain configured interval and retries.
已知的限制：
- Some time zone may need to be set again after upgrade.
- If remote management is enabled for WAN1 and the inbound rule is added in the router for ANY protocol on WAN1 then after upgrade the remote management will be enabled for WAN2
- WAN address may not be accessible after adding a rule for IPs to map (1-to-1 NAT) to consecutive private IPs
- SSL VPN Full tunnel on Mac 10.6 may not work sometimes
- SSL VPN logs page not showing logs when SSL and port forwarding users disconnected.
- DUT GUI is not accessible after establishing & deactivating port forwarding tunnels repeatedly
- HTTP traffic is not running when port forwarding tunnel is established using Firefox. - Workaround available
- User cannot be deleted when user name contains character: + and not showing user name in edit page.
- Guest users able to change their password from the User Portal page.
- Unable to edit the IPSec VPN user while in use
- Downgrade from M10 to M9 firmware configured with custom SSL tunnels requires a factory reset.
升级方法：
FVS336G 升级到 Version 2.X 后需重新恢复出厂设置值，Version1.X 和 2.X 的配置文件不能兼容，因此不要把Version1.X 配置文档用到 Version 2.X 的软件版本上。
1、升级步骤
- 点击下面的按钮下载升级文件到你的电脑上。
 13.9MB
- 通过浏览器登陆到管理界面。
- 点击 Administration>Settings Backup & Upgrade 管理菜单，在 Router upgrade 选项中点击“浏览”选中刚才下载的 img 升级包。
- 点击 Upload。
- 等待文件传输完毕，路由器将会重新启动，等待直到路由器的 TEST 指示灯熄灭之后，路由器的升级完成。
- .通过路由器前面面板的 Facotry Default 按扭或管理界面 Administration>Settings Backup & Upgrade的Default 按扭恢复出厂设置值。
2、FVX538/ FVS338/FVS336G V2.0 以上软件升级注意事项
如果在升级的过程中出现问题，可以通过路由器面板上的复位按钮对路由器进行恢复出厂配置的方法尝试恢复，在路由器正常启动之后，再手动对其进行重新配置。
This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR,s Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL. |
